Fronius PV-Genset Easy solution
POWER SUPPLY CIRCUIT
|AC voltage||230 VAC (-15 % bis +10 %)|
|Frequency||45 - 65 Hz|
|Nominal output||1% ± 1 digit|
|Nominal voltage||300 VAC (ph-n) / 520 VAC (ph-ph)|
|Frequency||46 - 65 Hz|
|Degree of protection||Built-in equipment: IP 41|
Terminals: IP 20
|Dimensions (Width)||52,5 mm|
|Dimensions (Height)||85 mm|
|Dimensions (Depth)||67,9 mm|
|Operating temperature||-10°C - +50°C|
|Relative humidity (non-condensing)||5 - 95 %|
|Max. altitude||2.000 m|
FRONIUS PV-GENSET SOLUTIONS
You can find further information on the Fronius PV-Genset solutions here.
FRONIUS PV-GENSET EASY SOLUTION
The inverter converts the direct current from the solar modules into alternating current and provides the PV-Genset system with as much PV energy as possible.
The Fronius PV system controller measures all power flows in the system, enabling it to control the PV power in the most optimum manner.
The diesel generator is the primary source of energy in the PV-Genset system. The PV energy relieves the diesel generator, which saves fuel.
The consumers are supplied with the optimal mix between fossil and solar energy by the PV-Genset system.
The current sensors are attached to the PV system controller and measure the power flow in the system.
A grid connection may be available though suffering from limited availability.
The backup feedback relay contactor enables the PV system controller to operate not only in isolated grids but in backup scenarios as well.